Hubzone Senior Electrical Engineer

Parra Consulting Group, Inc. is currently seeking a Senior Electrical Engineer to support our client located at Aberdeen Proving Grounds, Maryland.

HUBZone residence is a requirement for this job. Please confirm your residence is within a HUBZone by clicking the link below before applying for this position.
https://maps.certify.sba.gov/hubzone/map#center=39.828200,-98.579500&zoom=5 .

This successful candidate will be responsible for the following:

• Assist in engineering discipline activities for conducting electronic system, subsystem and component level characterization, reverse engineering, and replication.

• Provide hands-on physical, operational, and signals characterization of custom, commercial off the shelf (COTS), and hybrid custom/COTS circuits.

• Provide hands-on technical forensic exploitation (TFE) support for technical intelligence (TECHINT), media exploitation (MEDEX), cell phone exploitation (CELLEX), electronic exploitation (ELEX), and other unique exploitation missions.

• Prepare technical reports, briefs, operational diagrams, and schematics based on device characterization and analysis requirements.

• Identify trends and evolutions in commercial based technology (CBT) equipment and utilization.

Qualifications Required:

• Active Top-Secret Clearance with the ability to obtain SCI.

• MA/MS and 10yrs experience or BA/BS in Electrical Engineering and 18 years of experience

• Experience in electronic schematic generation and printed circuit board (PCB) layout.

• Solid background in practical electronics and/or RF theory.

• Basic understanding of RF communications, with emphasis on characterization of electronic circuits.

• Experience conducting time and frequency domain measurements using benchtop equipment, to include signal generators, arbitrary waveform generators, spectrum analyzers, oscilloscopes, protocol analysis tools, and other equipment.

• Experience performing standard RF measurements (e.g., operating frequency, occupied bandwidth, average power, pulse width, etc.) using the previously listed test equipment.

• Experience with soldering and re-working electronic circuit boards and components (e.g. through-hole, surface mount, cable assemblies, wire harnesses).

Qualifications Are Nice TO Have:

• Experience in reverse engineering electronic circuit boards and components.
• Basic MATLAB (and other basic programming / scripting) skills. Should be able to apply digital processing techniques to communication signals. Techniques may include digital filtering, sample rate conversion, frequency/phase estimation, modulation, demodulation, carrier recovery, timing recovery, channel equalization, pulse shaping, and forward error correction.
• Experience working with microcontrollers and embedded systems such as Arduino and writing custom programs to configure and control COTS devices such as transceiver system on chip (SoC) and other programmable devices.